300zx start to have problems?

have a 94 300zx and has been acting very strange in recent weeks. It starts fine after having been sitting over night or for several hours, but if I kill the engine then tries to Crank It Up is over but not start. What could be the cause of this, when the car starts driving with zero problems will not only begin once they have been murdered at least 2 hours. the dealer where it has had on the thing occasionally for 3 weeks and has led to nothing. they took my alarm out of the aftermarket, check accumulate carbon on the valves, the valve looked EGR, but it was okay, I cleaned the injectors, checked the fuel supply system, starter and nothign raised no flag. I was told my ignition switch be indeed, they often check out okay in the diagnostic test, but are really bad. Any input or suggestions would be great

If the relay boot will not even deliver, so it was. You need three things to run – fuel, spark and compression. Get a timing light or a verifier inductive spark. Plug it into each spark plug wire and look smoother, firmer flashing each as an assistant attempts to start the vehicle. Then use a pressure gauge to check fuel at the proper pressure fuel line during boot up attempt. Finally, pull your plugs and use a tester compression to check your cylinders. If one of these fails, you know where to start looking.

Left 4 dead 2 E3 09 PC gameplay – Stop The Alarm

Comments are closed